Gleason no. 635 CNC G-Plete Hypoid Gear Generator - 2 pcs.

Gear Diameter Maximum:                                                        711 mm
Maximum Radial Setting:                                                         266 mm
Full Depth-Maximum:                                                             31.8 mm
Face Width-Maximum:                                                           116.8 mm
Diameter of Taper Hole:                                                           152 mm
Cutter Diameters:                                        200/250/320/400/500 mm
Floor Space:                                                          539 x 346 x 295 cm

Siemens Sinumerik 3 CNC

Location: our warehouse near Oradea, Romania

The following gear cutting methods can be performed on the 635:

- complete generated gears
- complete pinions of generated or FORMATE pairs using Duplex Helical method, including Helixact System
- rough generated gears
- rough pinions of generated or FORMATE pairs
- finish generated pairs
- finish pinions of generated or FORMATE pairs using any single-side tilt type development method
- complete FORMATE pairs
- finish FORMATE pairs
- rough FORMATE pairs
- carbide hard finish gears and pinions

The following features and cycles are provided for the cutting methods listed above:

- Variable plunge feed
- Helical motion
- Sliding base set-in
- Work setover
- No roll cycle for FORMATE gears
- Variable rate of roll
- Double roll
- Dual rotation for genearted or FORMATE gears
- Modified roll
- Variable speed cutter drive